User manual

The following graphic illustrates how to integrate the unit into a DMX conguration.
Use the product (S) as the last part of the DMX chain that begins with your DMX controller (C).
Do do so, connect the output of the last device to the input of the DMX splitter.
You can connect one DMX chain to each active DMX output of the device (S) (DMX splitter).
Connect the output of the rst DMX device to the input of the second and continue this way
until all devices are connected. Make sure that the output of the last DMX device in the chain is
terminated by a resistor (110 Ω, ¼ W). You can even expand the conguration of your DMX
network if you are running additional DMX splitters at the end of the DMX chains. Keep in
mind that the total number of usable DMX addresses in a ‘DMX universe’ is limited to 512.
On the passive DMX output, the signal is looped through to a connected device.
DMX connections
Starting up
DMX splitter
14