User manual

7 Operating

7.1 Switching the device on / o

Perform the following steps to switch the device on:

1. Verify that all required laser safety precautions have been taken. Make sure that there is

no one in the reach of the laser beam.

2. Connect an external safety switch [REMOTE] to the port (e.g. emergency stop) or any

other comparable installation using a protection function.

3. Insert the safety key into the lock.

4. If not already connected, connect the device to the mains.

5. Using the main switch, turn the device on. After a few seconds, the fan and the motors

start to work. The display shows the current operation mode. The device is now opera‐

tional.

6. Turn the safety key to the “ON” position to turn the laser beam on.

Switching the device on

Operating

showlaser