Installation Guide

and working to the walls in sections. Keep the dry layout in mind when setting up the initial glue lines.
c. Spread adhesive in an area that can be installed within the working time of the adhesive. Some slippage of the
plank/tile may occur with a “wet” method. Be careful to follow layout lines and allow adhesive to set before rolling.
See Section above for proper adhesive installation and use.
d. After determining the starting point and spreading your adhesive; lay the flooring by tightly butting the edges of
the pieces together, making sure that the runs are parallel to your centerline or layout lines.
e. Be sure to stagger all end joints by at least 6” or the width of one plank. Vary the length of your planks during installation
to ensure that end joints are not bunched and a randomness is achieved in the pattern.
f. If you need to be directly on freshly laid planks, use of a kneeling board is recommended to evenly distribute weight
across the planks and keep them from creeping in the wet adhesive.
g. During installation, roll the floor with a 3-section 100 lb. roller to ensure proper transference of adhesive to the
plank backing.
h. Continue in this manner spreading only enough adhesive that can be safely installed within the working time of the
adhesive.
Instructions for installing with grout
Product Handling and Limitations
a. Store indoors in a cool, dry location and keep away from excessive heat.
b. Maintain temperature range of 60° - 100°F (15° - 38°C) during use and drying.
c. Grout is freeze/thaw stable to -10°F. If grout does get frozen, slowly bring material back to room temperature and
mix per instructions.
d. Follow all instructions, cautions, limitations, storage recommendations and usage recommendations of the grout
manufacturer. Consult with grout manufacturer for latest instructions on use of their product.
e. Grout joints shall be a minimum of 1/6” and not greater than 3/16”.
f. Be sure you have the proper amount of grout before beginning the job. Approximate coverage of grout with
STAINMASTER
®
luxury vinyl direct-glue flooring is shown in the table below.
g. Tiles must be clean and well bonded to the substrate before grout is applied.
h. Do not grout immediately after installation, wait 24 hours.
i. Grout joints must be clean and dry, use of a vacuum is recommended to ensure there is no debris in the joints.
j. Use of a rigid rubber float is recommended.
k. Remove all joint spacers before installing grout.
Installing the Grout
a. Area must be clean, dry, free of dirt, dust and debris.
b. Begin grouting in one corner of the work area away from the exit, working across the room and backwards toward
the exit.
AUGUST 2016 8
Direct Glue Flooring
Installation Instructions