Warranty Guide

Cautions / Warnings
Always pre-test spot cleaners in an inconspicuous area.
Never use bleach-based spot cleaners on any carpet other than our Bliss
Ultimate Home, Bliss SoftSense Solution Dyed Polyester and Hollytex Ulti-
mate Performance Solution Dyed Nylon carpets. Also, never use bleach based
spot cleaners immediately after using ammonia-based spot cleaners.
Never use solvents near open flames, or in areas that are not adequately
ventilated, or apply them directly to your carpet.
Avoid using hydrogen peroxide to clean any product that contains benzoyl
peroxide.
Do not saturate your carpet when spot cleaning.
• Never use any spot cleaning solutions in concentrations stronger than those
recommended.
Never walk on a spot cleaned area before it has thoroughly dried.
STAIN REMOVAL METHODS
Dampen a white terry cloth towel and then blot clean using these spot cleaners.
Step 1 – Detergent and water- Mix ½ teaspoon of dish detergent (with no bleach
or lanolin) to one (1) pint lukewarm water. Follow spot cleaning by blotting with
clear water using a white terry cloth towel.
Step 2 – Warm Water Rinse - Dampen a white terry cloth towel with lukewarm
water and blot affected area.
Step 3 – Dry Cleaning Solvent or Citrus Solvent Solvents can be found in your
local hardware store or supermarket. (Nail polish remover with Acetone can be
substituted when spot cleaning small stains.)
Step 4 – Isopropyl Alcohol
Step 5 3% Hydrogen Peroxide - Follow by blotting with clear water using a
white terry cloth towel. DO NOT attempt to clean acne medication, cosmetics, or
hand cream stains using hydrogen peroxide.
Step 6 – Vinegar and water Mix 1 cup of white vinegar with 2 cups of water.
Follow spot cleaning by blotting with clear water using a white terry cloth towel.
Step 7 – Ammonia and water - Mix 2 tablespoons of household ammonia with
1 cup water. Follow spot cleaning by blotting with clear water using a white terry
cloth towel.
Step 8 – Nail Polish Remover with Acetone
Step 9 – Vacuum
7