Warranty Guide

Cautions / Warnings
• Always pre-test spot cleaners in an inconspicuous area.
• Never use bleach-based spot cleaners on any carpet other than our Bliss
Ultimate Home, Bliss SoftSense Solution Dyed Polyester and Hollytex Ulti-
mate Performance Solution Dyed Nylon carpets. Also, never use bleach based
spot cleaners immediately after using ammonia-based spot cleaners.
• Never use solvents near open flames, or in areas that are not adequately
ventilated, or apply them directly to your carpet.
• Avoid using hydrogen peroxide to clean any product that contains benzoyl
peroxide.
• Do not saturate your carpet when spot cleaning.
• Never use any spot cleaning solutions in concentrations stronger than those
recommended.
• Never walk on a spot cleaned area before it has thoroughly dried.
STAIN REMOVAL METHODS
Dampen a white terry cloth towel and then blot clean using these spot cleaners.
Step 1 – Detergent and water- Mix ½ teaspoon of dish detergent (with no bleach
or lanolin) to one (1) pint lukewarm water. Follow spot cleaning by blotting with
clear water using a white terry cloth towel.
Step 2 – Warm Water Rinse - Dampen a white terry cloth towel with lukewarm
water and blot affected area.
Step 3 – Dry Cleaning Solvent or Citrus Solvent – Solvents can be found in your
local hardware store or supermarket. (Nail polish remover with Acetone can be
substituted when spot cleaning small stains.)
Step 4 – Isopropyl Alcohol
Step 5 – 3% Hydrogen Peroxide - Follow by blotting with clear water using a
white terry cloth towel. DO NOT attempt to clean acne medication, cosmetics, or
hand cream stains using hydrogen peroxide.
Step 6 – Vinegar and water – Mix 1 cup of white vinegar with 2 cups of water.
Follow spot cleaning by blotting with clear water using a white terry cloth towel.
Step 7 – Ammonia and water - Mix 2 tablespoons of household ammonia with
1 cup water. Follow spot cleaning by blotting with clear water using a white terry
cloth towel.
Step 8 – Nail Polish Remover with Acetone
Step 9 – Vacuum
7