User's Manual

Installation
73
4. Wait ten seconds for the Station Management Menu to appear, then type getprov to list the default
initial STS configuration.
5. Use the setprov command to change the values of the RF Channel and the Distance parameters to
reflect the STS’s requirements. It may also be necessary to change the IP address of the STS.
" Type setprov rfchannel x, where x is the code assigned to the frequency channel as list in
Table 3.7 on page 74.
" Type setprov wtdist y, where y is the distance (in 100 meters) between the STS and SBS. For
example, y= 8 means 800 m (0.8 km).
6. Use the reset command to save the new configuration.
" Type reset.