Instructions / Assembly

ManualsBrandsSPRAYIT ManualsKitchenLVLP Mini Gravity Feed Forged Aluminum Spray Gun

- 1 -

Model No. SP-34000

Low Volume Low Pressure (LVLP)

Mini Gravity Feed Forged Aluminum Spray Gun

TABLE OF CONTENTS:

1. Description

2. Specification and Technical Data

3. Important Safety Instruction

4. Instructions for Operation

5. Maintenance/Storing

6. Troubleshooting/Repairs

7. Parts List

8. Warranty Information

Summary of content (7 pages)

PAGE 1
Model No. SP-34000 Low Volume Low Pressure (LVLP) Mini Gravity Feed Forged Aluminum Spray Gun TABLE OF CONTENTS: 1. Description 2. Specification and Technical Data 3. Important Safety Instruction 4. Instructions for Operation 5. Maintenance/Storing 6. Troubleshooting/Repairs 7. Parts List 8.
PAGE 2
1. Description The SPRAYIT SP-34000 LVLP Mini Gravity Feed Forged Aluminum Spray Gun is designed with the professional in mind. The Low Volume Low Pressure feature allows for more control with less overspray and waste. The LVLP feature requires less air volume allowing you to use with a smaller portable air compressor. The high efficiency transfer of coatings produces a more even covering.. A one-piece Lightweight Forged Aluminum Gun Body with 4.20 oz.
PAGE 3
. Important Safety Instructions 1. Toxic vapors produced by spraying certain materials can create intoxication and serious damage to your health. Always wear safety glasses, gloves and respirator to prevent toxic vapor hazard and solvent coming into contact with your noise, eyes or skin. (See fig 1) 2. Never use oxygen, combustible or any other bottle gas as a power source. This would 1 cause explosion and serious personal injury. (See fig 2) 3. Fluid and solvent can be highly flammable or combustible.
PAGE 4
B. Adjustments The desired pattern, volume of fluid output and fine atomization can easily be obtained by regulating the Pattern Adjusting Knob, Fluid Adjusting Knob and Air Adjusting Knob. PATTERN ADJUSTMENT: Turning Pattern Adjusting Knob to the right until tight will make spray pattern round, or turning left make spray pattern ellipse. FLUID (PAINT) ADJUSTMENT: Turn the Fluid Adjusting Knob clockwise will decrease the volume of fluid output and counter-clockwise will increase fluid output.
PAGE 5
Storing   When not using spray gun, turn the fluid adjustment knob counter-clockwise to open which will reduce spring tension on needle fluid tip. Spray gun MUST BE well cleaned and lightly lubricated 6. Trouble Shooting Symptom Problems Solution Fluttering or spitting 1. 2. 3. 4. 5. Material level too low. Container tipped too far. Loose fluid inlet connection. Loose or damaged fluid tip/seat. Dry or loose fluid needle packing nut. 6. Air vent clogged 1. 2. 3. 4. 5. 6. Pattern is arc. 1.
PAGE 6
7. Parts List Note: If you need parts of this model, contact us or the distributor where you bought this product.
PAGE 7
8. Warranty Disclaimers and Limitations of Remedies This warranty gives you specific legal right, and you may also have other rights which may vary from State to State.