Model No.
TABLE OF CONTENTS: 1. Description 2. Specification and Technical Data 3. Important Safety Instruction 4. Instructions for Operation 5. Maintenance/Storing 6. Troubleshooting/Repairs 7. Parts List 8. Warranty Information 1. Description The SPRAYIT SP-31000 LVLP Siphon Feed Spray Gun can be used for variety of different applications such as Automotive, Industrial, Marine and Wood Working. The LVLP features require less air allowing you to use a smaller air compressor.
. Important Safety Instructions 1. Toxic vapors produced by spraying certain materials can create intoxication and serious damage to your health. Always wear safety glasses, gloves and respirator to prevent toxic vapor hazard and solvent coming into contact with 1 your noise, eyes or skin. (See fig 1) 2. Never use oxygen, combustible or any other bottle gas as a power source. This 图表 1 would cause explosion and serious personal injury. (See fig 2) 3.
Adjustment The desired pattern, volume of fluid output and fine atomization can easily be obtained by regulating the Pattern Adjusting Knob, Fluid Adjusting Knob and Air Adjusting Knob. PATTERN ADJUSTMENT: Turning Pattern Adjusting Knob to the right until tight will make spray pattern round, or turning left make spray pattern ellipse. Material (PAINT) ADJUSTMENT: Turn the Paint Adjusting Knob clockwise will decrease the volume of fluid output and counter-clockwise will increase fluid output.
WARNING: NEVER USE METAL OR OTHER OBJECTS THAT COULD DAMAGE THE HOLES IN THE NOZZLE AND CAP. NEVER IMMERSE THE SPRAY GUN COMPLETELY IN SOLVENT. NEVER USE COMPONENTS OR PARTS THAT ARE NOT MANUFACTURER ORIGINALS. Storing When not using spray gun, turn the fluid adjustment knob counter-clockwise to open which will reduce spring tension on needle fluid tip. Spray gun MUST BE well cleaned and lightly lubricated.
. Trouble Shooting Symptom Problems Solution Fluttering or spitting 1. 2. 3. 4. 5. Material level too low. Container tipped too far. Loose fluid inlet connection. Loose or damaged fluid tip/seat. Dry or loose fluid needle packing nut. 6. Air vent clogged 1. 2. 3. 4. 5. 6. Pattern is arc. 1. Worn or loose Fluid nozzle. 2. Material builds up on Air cap. 1. Tighten or replace Fluid nozzle. 2. Remove obstructions from holes, But don’t use metal objects to clean it. Pattern is not Evenly spread. 1.
. Parts List Note: No Description No Description No Description 1 Air Adj. Screw 19 Needle Housing 37 Washer 2 Air Adj. Knob 20 Washer 38 Nut 3 O-ring(3.15*1.8) 21 O-ring(4.5*1.2) 39 Air Cap Washer 4 Washer 22 Washer 40 Atomization 5 Air Valve Spring 23 Washer 41 Paint Inlet Nozzle 6 Snap Retainer 24 Spring core 42 Nut 7 Air Inlet Valve pole 25 Switch spring 43 Nut 8 Air Inlet Joint 26 Snap Retainer 44 Hanger 9 washer 27 Fluid Adj.
. Warranty Disclaimers and Limitations of Remedies This warranty gives you specific legal right, and you may also have other rights which may vary from State to State.
