Model No.
TABLE OF CONTENTS: 1. Description 2. Specification and Technical Data 3. Important Safety Instruction 4. Instructions for Operation 5. Maintenance/Storing 6. Troubleshooting/Repairs 7. Parts List 8. Warranty Information 1. Description The SPRAYIT SP-33000 LVLP Gravity Feed Spray Gun can be used for variety of different applications such as Automotive, Industrial, Marine and Wood Working. The LVLP features require less air allowing you to use a smaller air compressor.
. Important Safety Instructions 1. Toxic vapors produced by spraying certain materials can create intoxication and serious damage to your health. Always wear safety glasses, gloves and respirator to prevent toxic vapor hazard and solvent coming into contact with 1 your noise, eyes or skin. (See fig 1) 2. Never use oxygen, combustible or any other bottle gas as a power source. This 图表 1 would cause explosion and serious personal injury. (See fig 2) 3.
Adjustment The desired pattern, volume of fluid output and fine atomization can easily be obtained by regulating the Pattern Adjusting Knob, Fluid Adjusting Knob and Air Adjusting Knob. PATTERN ADJUSTMENT: Turning Pattern Adjusting Knob to the right until tight will make spray pattern round, or turning left make spray pattern ellipse. Material (PAINT) ADJUSTMENT: Turn the Paint Adjusting Knob clockwise will decrease the volume of fluid output and counter-clockwise will increase fluid output.
WARNING: NEVER USE METAL OR OTHER OBJECTS THAT COULD DAMAGE THE HOLES IN THE NOZZLE AND CAP. NEVER IMMERSE THE SPRAY GUN COMPLETELY IN SOLVENT. NEVER USE COMPONENTS OR PARTS THAT ARE NOT MANUFACTURER ORIGINALS. Storing When not using spray gun, turn the fluid adjustment knob counter-clockwise to open which will reduce spring tension on needle fluid tip. Spray gun MUST BE well cleaned and lightly lubricated.
. Trouble Shooting Symptom Problems Solution Fluttering or spitting 1. 2. 3. 4. 5. Material level too low. Container tipped too far. Loose fluid inlet connection. Loose or damaged fluid tip/seat. Dry or loose fluid needle packing nut. 6. Air vent clogged 1. 2. 3. 4. 5. 6. Pattern is arc. 1. Worn or loose Fluid nozzle. 2. Material builds up on Air cap. 1. Tighten or replace Fluid nozzle. 2. Remove obstructions from holes, But don’t use metal objects to clean it. Pattern is not Evenly spread. 1.
. Parts List No Description No Description No Description 1 Air Adj. Screw 16 Switch pole 31 Ventilator Head 2 Air Adj. Knob 17 O-ring (8.5*1.2) 32 Snap Retainer 3 O-ring 3.3X1.5 18 O-ring (10.7*1.8) 33 Trigger 4 Flat washer 19 Needle Housing 34 Trigger Lever 5 Air valve spring 20 Cover Washer 35 Atomization 6 Air Valve step 21 O-ring(4.5*1.
. Warranty Disclaimers and Limitations of Remedies This warranty gives you specific legal right, and you may also have other rights which may vary from State to State.
