User's Guide
Table Of Contents
- 1 - Introduction
- 2 - Getting Started
- 3 - Mounting the DU
- 4 - Installation
- 5 - Display Information
- 6 - Trouble Shooting Information
- Appendix A - SpotCell 100 Series Specifications
- Appendix B - SpotCell 111 System Specifications
- Appendix C - SpotCell 112 System Specifications
- Appendix D - SpotCell 111s/112s System Specifications
- Appendix E - SpotCell 163 System Specifications
- Appendix F - SpotCell 141/142 System Specifications
- Appendix G - Safety Hints
Spotwave Wireless Inc. 15
2. If mounting on a solid wood surface, or stud covered by drywall,
drill a 1/8th inch diameter hole and fasten the mounting clip with
#6 x 1.5” screws.
or
If mounting in drywall, drill a ¼ inch diameter hole, insert the
nylon screw anchor, and then fasten the mounting clip with a 1/2”
pan head screw.
Note: The mounting clip must be positioned a least 4 inches from the
ceiling to allow the CU to slip into the bracket.
3. Attach cables to the wall using tie wraps and mount directly to the
wall where possible (using 1/2 inch pan head screws). If an anchor is
required drill a 3/16 inch diameter hole, insert the anchor, and
fasten with 1/2 inch screws.
Mounting other (non dual or split band) CUs
1. Find a suitable location to mount the unit that will provide good
signal coverage. Refer to section 4.3“Choosing a location for the
SpotCell CU”.
2. If mounting on a solid wood surface, or stud covered by drywall,
drill a 1/8th inch diameter hole and mount with #6 x 1.5” screws.
or
If mounting in drywall, drill a ¼ inch diameter hole, insert the
nylon screw anchor, and then mount with a 1/2” pan head screw.
3. Attach cables to the wall using tie wraps and mount directly to the
wall where possible (using 1/2 inch pan head screws). If an anchor is
required drill a 3/16 inch diameter hole, insert the anchor, and
fasten with 1/2 inch screws.