Instructions

23
Finally, protective caps must be pressed onto the
sheath nuts to ensure hand safety against uninten-
tional touch.
To close the housing, the seal’s half-shells must be
brought into position and then the cover must be
closed. Any dirt on the seal must be removed and
the seal’s half-shells must lie neatly on top of each
other to ensure optimum sealing.
Cover screws must be tightened such that the posi-
tion markings fit together without a gap. Tightening
torque of the cover screws must not exceed 6 Nm.
The installation of the Rapid-Box
HT
switchgear combination is now locked.
ENGLISH