Box Contents: 1 2 3 4 5 7 9 11 12 13 14 (Washer) 2
Part Number 1. Part Stop Nut Quantity 1 2. Hammer 1 3. 5. Upper Hammer 1 Guide Steel Reinforced 1 Bush Axe Guide 1 7. 20mm Drill Bit 1 9. 1 11. Lower Hammer Guide Thread Lock 12. Rubber Washer 1 13. Axe 1 14. Washer 2 4.
Assembly You will require a chopping block (a large log) that is at least 35cm in height and 35cm in diameter, a Philips screwdriver and two 10mm spanners. 1. In the chopping block, drill a hole with a diameter of 20mm, using the supplied drill bit (7). The hole must be placed at least 8cm in from the edge of the chopping block and be 12cm deep. 2. Place the Axe Guide (5) into the hole and make sure it is secure and as far down as possible by hitting the top with a mallet. 3.
1 2 4 3 9 13 14 12 14 5 5
Using Smart Splitter Make sure you have read and understood the safety guidelines before you use the log splitter. Always wear the correct protective safety gear when using the splitter. Splitting Logs · Place a log on the cutting block, lift the axe by the handle and place the blade on top of the log at the desired splitting position (The most efficient position is the back of the blade at the edge of the log).
Safety Guidelines Always read and adhere to the safety guidelines provided in this handbook. Misuse of this product could lead to serious injury. Only persons over the age of 16 are permitted to use the smart splitter. · The splitter should only be used on a flat, stable surface. Make sure the · · · · · · · · · · · chopping block does not move during operation. Make sure the axe guide is firmly into the drilled hole. There should be no movement of the axe guide during operation.
Español Contenido de la caja: 1 2 3 4 5 7 9 11 12 13 14 (Arandela ) 9
Español Número de pieza 1. 2. 3. 4. 5. 7. 9. 11. 12. 13. 14.
Español Ensamblaje Necesitará un tajo (un tronco grande) de al menos 35 cm de altura y 35 cm de diámetro, un destornillador Philips y dos llaves fijas de 10 mm. 1. En el tajo, taladre un orificio con un diámetro de 20 mm, utilizando la broca suministrada (7). El orificio debe colocarse a una distancia mínima de 8 cm del borde del tajo y tener una profundidad de 12 cm. 2.
Español 1 2 4 3 9 13 14 12 14 5 12
Español Utilizar el partidor inteligente Asegúrese de que ha leído y comprendido las pautas de seguridad antes de usar el partidor de troncos. Use siempre el equipo de seguridad de protección correcto cuando use el partidor.
Español Pautas de seguridad Lea y respete siempre las pautas de seguridad que se proporcionan en este manual. El uso incorrecto de este producto podría provocar lesiones graves. El partidor inteligente solo debe ser usado por personas mayores de 16 años. • El partidor solo debe utilizarse en una superficie plana y estable. Asegúrese de que el tajo no se mueva durante la operación. • Asegúrese de que la guía del hacha esté firmemente sujeta en el orificio taladrado.
Español 15
Technical Info and Support For technical support or if you have any questions, please contact us Para soporte técnico o si tiene alguna pregunta, contáctenos North America Dealer and support: SPEEDFORCEUSA Email: service@speedforceUSA.