Instructions / Assembly
Royale/Ellington
Installation Instructions
For quick and easy installation of your folding door, read
these instructions thoroughly.
The Tools You Will Need
You will need a Drill, Phillips screwdriver bit, 3/32” drill bit for
pilot holes, small Phillips head screwdriver, tape measure,
pencil, ne tooth hacksaw (for cutting the top track), safety
glasses and ne sandpaper (can be used to smooth edges
after cutting top track) and a level.
Make sure all of the following Parts are
included before you begin:
Door Parts Location
SINGLE DOOR INSTALLATION
1. Measure the Door Opening
Measure the height and
width of your nished
opening. This door ts
openings that are 24” to
36” wide and 80” high.
The door height cannot
be trimmed or altered.
If the height of your
door opening is
approximately 80”, you
will not need to alter the height of the door. If the opening is
less than 80” high, the door may be shortened by sawing the
excess from the bottom of the door panels.
Trimming the Door Height and Top Track:
Stack the door panels together and secure with masking
tape. Remove bottom hinge screws. Cut excess o with a
hacksaw or le.
2. Install the Top Track
Cut the top track 1/8”
shorter than the width
of the nished opening.
Position the top track
in the top of the door
opening so that it is
straight and centered.
After making a pi-
lot-hole (with a 3/32”
drill bit), insert a 1”
track screw through the
pre-drilled hole nearest
the center of the track.
Do not fully tighten. (Tape may be used to hold the track in
place while you mark and drill.)
3. Attach the Handle
Tap the two handle
attachment pins into
one handle, then t the
pins through the door
panel holes. Press the
other handle onto the
pins.
If necessary, you may
back one handle with
a solid object and tap
the other handle
alternately over each
pin area until the
handles are seated.
2 Ea.
Door
Handle
Pins
1 Ea.
36” Top Track
1 Ea.
Closure
Channel
1 Ea.
Anchor
Channel
1 Ea. Locking Clip
6 Ea. (1”)
Anchor Clip Screws
14 Ea. (1”)
Flat Head Screws
1 Ea.
Locking Clip Screw
Anchor
Channel
Top Track
Closure
Channel
Locking
Clip
Handle
2 Ea.
Door
Handle
Top Glide
Anchor
Panel
Lead
Edge
1 Ea.
Spare Top
Glide Screw
1 Ea.
Spare
Top Glide