Installation Guide

For quick and easy installation of your folding door, read
these instructions thoroughly. A few minutes of prior
planning will make the job easier and will ensure years of
trouble-free use.
The Tools You Will Need
You will need a small #1 Phillips screwdriver, a athead
screwdriver, a tape measure, a small nail, and a 3/32” drill bit
for pilot holes , a hacksaw or ne tooth saw (saw needed to
trim top track for the appropriate width or to trim height of
panels if necessary). Masking tape (to secure doors if
trimming is necessary.) Safety glasses. Fine sandpaper (used
to smooth edges after trimming).
SINGLE DOOR INSTALLATION
1. Measure the Door Opening
If the height of your door opening is
approximately 96”, you will not need
to alter the door itself. If the opening
is less than 96” high, the door may be
shortened by sawing o excess from
the bottom of the door panels.
To Trim Height and Top Track
Stack the door panels together and
secure with masking tape. Remove
bottom hinge screws. Cut excess with
a hacksaw or ne tooth saw. Cut the
top track 1/8”shorter than the width of
the opening. Reinsert hinge screws.
2. Install the Top Track
Position the top track on the top of the door opening so
that it is straight and
centered.
After making a pilot hole (with a nail or a 3/32” drill bit),
drive a 1” track screw through the screw hole
nearest the center of the
track. Do not tighten fully at
this point to allow the track to
swing out for Step 4. (Tape
may be used to hold the
track in place while you mark
and drill.)
3. Install the Handles
Tap the two handle
attachment pins into one handle, then t the pins through
the door panel holes. Press the other handle onto the
pins.
If necessary, you may back one handle with a solid object
and tap the other handle alternately over each pin area
until the handles are
seated.
Do not strike the middle
of either handle.
4. Install the Door
Panels
Swing one end of the
top track out of the door
opening to accept the
top glides.
Decide if you want the
door to open from the left or the right,
then slide all top
glides onto the track.
Stack the panels
together near the center
screw.
INSTALLATION INSTRUCTIONS
Make Sure All The Following Parts Are
Included With Your Folding Door:
Door Parts Location
Elite 96”
Top Track
Guía superior
Top Glides
Patines superiores
Channel Clips
Ganchos para el canal
Anchor Panel
Panel de fijación
Striker Plates
Resbalón Placas
Closure Channel
Canal de cierre
Lead Edge
Borde delantero
Handle
Manija
Magnets
el imáns
96” Door
19 Flathead Screws (1”)
6 - Channel Clips
6 - Closure Channel
6 - Striker Plates
1 - Extra Screw