Manual

37
Figure 5-19
Refer to the following table for more information. Typically, if the device is being installed on an NVR or
SecureGuard in the same LAN, these ports can stay at the same values.
Parameter Function
Max
connection
Defines the number of max web connections that are allowed for the device. The
value ranges from 1 to 20. Default connection amount is 10.
TCP port Port range is 1025~65534. The default value is 37777.
UDP port Port range is 1025~65534. The default value is 37778.
HTTP port Port range is 1025~65524. The default value is 80.
RTSP port The default value is 554.
HTTPs Port HTTPs communication port, range is 1025~65534, default is 443.
Note:
 0 ～ 1024, 37780 ～ 37880, 1900, 3800, 5000, 5050, 9999, 37776, 39999, 42323 are all special ports. User
cannot modify them.
 Avoid using default values of other ports.
5.2.3 PPPoE
The PPPoE interface is shown in Figure 5-20.
Enter the username and password that were provided by the ISP, and click “Enable”. The network camera will
automatically establish a network connection if the credentials are correct. The IP address will be automatically
modified to the dynamic IP address of the acquired WAN.
Note:
Disable UPnP before enabling PPPoE, which can cause a conflict.