Instruction Manual

AFTER SALES SUPPORT 0345 605 206824
Setting the cutting heights
IMPORTANT! Set the cutting height only when the motor
is switched off and the battery pack has been removed.
Stop the machine, release the switch lever, remove
the isolator key and wait until the blade stops before
adjusting the cutting height. Remember, the blade may
continue to rotate after the machine is switched off. A
rotating blade can cause injury.
CAUTION! Do not touch rotating blades.
Before using the mower for the first time, adjust the cutting
position to the height best suited for your lawn.
The mower can be set to 6 cutting heights between 22mm
and 72mm. Choose the appropriate cutting height according
to the type and conditions of the grass.
To set the cutting height:
1. To raise the cutting height, grasp the cutting height
adjustment handle, disengage the handle from its current
setting, then move it toward the back of the mower and
engage the handle in the desired cutting height position on
the mower deck.
2. To lower the cutting height, grasp the cutting height
adjustment handle, disengage the handle from its current
setting, then move it toward the front of the mower and
engage the handle in the desired cutting height position on
the mower deck.
For the first cut each season, a higher cutting setting should
be selected.
Using a cutting height that is too low in longer grass will use
more power and shorten battery run time. It is recommended
to cut longer grass in 2 passes or more. This method will also
cause less stress to your grass for a healthier lawn.
Before you begin to mow, check to ensure that the blade
is not blunt and that none of the fasteners are damaged.
To prevent any imbalance, replace blunt and/or damaged
blades. To carry out this check, first switch off the motor and
remove the battery and isolator key.
4
32
22
42
52
62
72
2
1
3
5
6
OPERATION
Cutting Position Cutting Height
1 22mm
2 32mm
3 42mm
4 52mm
5 62mm
6 72mm
22 mm
32 mm
42 mm
52 mm
62 mm
72 mm