Operation Manual
Soundcraft Vi Series™ User Guide 1112 Page 5 - 9
CHANGING OUTPUT BUS PARAMETERS
The following pages shows bus master processing using the Input strip (All Busses layer) mode as an
example. Parameter changing is done in the same way if either of the other two ways of accessing bus
masters is used.
Changing A Parameter Of A Bus
* Press the desired touch eld, the corresponding VST Area will open
* change the parameter
* Press the touch eld again to go back to the default VST view
or
* Press another touch eld.
Figure 5-8: The Relationship Between Touch Fields And Master Functions.
60
The picture shows the relation between touch fields and master functions.
Equaliser