Operation Manual

Soundcraft Vi Series™ User Guide 1112Page 14 - 18
HiQNET
Figure 14-15: Settings Page
HiQNet {ON}
Enables or disales the HiQNet ethernet port on the rear of the control surface.
HiQNet ADDRESS
Allows the HiQNet Address for the console to be edited. Every piece of equipment on a HiQNet network
must have a unique HiQNet address.
IP CONFIG: DHCP or MAN
Set to MAN if you wish tio manually set the IP address for the console, or to DHCP if you wish the address
to be assigned automatically by an external DHCP server (e.g. a network switch)
IP ADDRESS and SUBNET MASk
If the IP CONFIG mode has been set to MAN, the IP address and subnet mask controls allow these to be
set for the console. In an ethernet network, every piece of equipment must have a unique IP (Internet Pro-
tocol) address. Devices taht need to communicate with each other must be on the same subnet as each
other.
Note: when changing settings on the HiQNet page there will be a delay of up to several seconds before
the change is actioned. This normal, and is due to the conguration time of the internal network interface
hardware.