Operation Manual
Soundcraft Vi Series™ User Guide 1112 Page 10 - 5
OUTPUT
The Output Patch connects a master or bus out with an output connector or MADI channel. A master or
bus out signal can be patched to several physical outputs at the same time.
Figure 10-5: Output Patch Conguration Page.
Patch a BUS to an OUTPUT
There are two ways to access the Output Patch conguration page (Figure 10-5). They are summarised in
Figure 10-2. As an example of one of the two methods proceed as follows:
* Press one of the output fader page keys [A]-[D] on the master bay.
* Ensure [LOCK MTR] is not on, and that no Setup or Menu pages are open.
* Press the [SOLO/SEL] key for the bus to be assigned to an output (or press the [SEL] key
under the LR C faders to assign any of the three main output busses.
* Press the PAN area on the master section touch screen ( this is in the area that the input
meters were being displayed).
* Press the {BUS OUT} Patch button.
* Select the required output on the touch screen.
* Optionally select additional outputs.
* Leave the Patch page by pressing the OUT Patch button again, or the <EXIT> button on screen.
( The second method is to select the [ALL BUSSES] fader pages and access the PAN area for the required
output directly on the input fader screens.)
HINT: It is possible to select <NONE> to reset the patch.
Location groups (e.g., Stage box, Local I/O, etc) can be changed by directly selecting the alternate groups.
HINT: If you adjust a STEREO Bus the desired patch page can be selected with <LEFT> and <RIGHT> .