User's Manual

Operating Instructions

2Wireless Access Points

Connect the access point to the power supply

The AP 30, AP 50, and AP 100 can be powered directly through the Power-over-

Ethernet-injector. Note that it is also possible to power them by a PoE-compliant

switch. For more information on PoE-injectors, see below.

Connect the AP 10 and AP 15 to the power supply. Please use the power supply from

the scope of supply. Note that the AP15 can also be operated through a PoE-injector

or PoE-compliant switch.

Start the communication between the access point and the UTM appliance

When connected to the network, the access point will try to receive an IP address via

DHCP. Therefore, you need either the UTM appliance (with a DHCP server enabled

and listening on the interface the access point is connected to) or any other DHCP

server to provide an IP address for the access point.

After successfully receiving an IP address, the access point will communicate with

the UTM appliance. For this to happen, the UTM appliance needs to be put in the

upstream of the access points, either being the default gateway of the access points

(which was provided by the DHCP service) or on the default route (most likely your

route to the Internet).

Please note that the actual Internet access is not necessary to use UTM Wireless

Protection. While waiting for DHCP and searching for the UTM appliance, the access

point’s power LED will blink slowly.

Enable UTM Wireless Protection on the UTM appliance

In WebAdmin, navigate to the Wireless Protection menu entry. On the Global Settings

tab, click the Enable button. When enabling Wireless Protection for the ﬁrst time,

the Initial Setup frame will appear. It shows the conﬁguration which will be created:

A separate Wireless “Guest” network using WPA2 personal with DHCP for wireless

clients, which will be allowed to use DNS on the UTM appliance and the “Web

Surﬁng” service.

The pre-shared key is auto-generated and will only be shown in this section. This

conﬁguration is intended as a template, you can edit the settings at any time on the

Wireless Protection > Wireless Networks tab. You can also skip the initial setup by

ticking the checkbox on the bottom of the section.