Operating Instructions

42
Connection to the network allows you to
operate the following features.
Use the projector with only necessary
functions enabled.
Checking the current status of the unit
via a Web browser.
Making the network settings for the
unit.
Network monitoring and controlling
with control protocol (Advertisement,
ADCP, AMX DDDP (Dynamic Device
Discovery Protocol), Crestron
RoomView, Control4).
When connecting this projector with the
network, consult with the person who sets up
the network. The network must be secured.
When using this projector connected with the
network, access the Control window via a
Web browser and change the access
limitation of the factory preset values
(page 44). It is recommended to change the
password regularly.
When the setting on the Web browser is
completed, close the Web browser to log out.
The menu displays used for the explanation
below may be different depending on the
model you are using.
Supported Web browsers are Internet
Explorer (version 11 or later), Safari, and
Chrome.
The menu displays only English.
If the browser of your computer is set to [Use
a proxy server] when you have access to the
unit from your computer, click the check
mark to set accessing without using a proxy
server.
AMX DDDP is not compatible with IPv6.
These network functions are available when
the unit is turned on.
Displaying the
Control Window of
the Unit with a Web
Browser
1 Connect the LAN cable.
2 Set the network settings for the unit
using “Network Setting” on the
Installation menu
(page 40).
3 Start a Web browser on the computer,
enter the following in the address field,
then press the Enter key on your
computer.
http://xxx.xxx.xxx.xxx
(xxx.xxx.xxx.xxx: IP address for the
unit)
When connecting by the IPv6
address
http://[xxxx:xxxx:- xxxx]
You can confirm the IP address of the
unit under “Network Setting” on the
Installation menu.
The following window appears in the
Web browser:
Using Network Features
Notes
LAN
Connector
LAN cable
(straight type)
(not supplied)
Hub, router, etc.