User's Manual

Using Network Features

Network

B Network

Using Network Features

Connection to the network allows you to operate the following features:

• Checking the current status of the projector via a Web browser.

• Remotely controlling the projector via a Web browser.

• Receiving the e-mail report via the projector.

• Making the network settings for the projector.

• Supports network monitoring, control protocol (Advertisement, PJ Talk, PJ Link, AMX

DDDP [Dynamic Device Discovery Protocol]).

• The menu displays used for the explanation below may be different depending on the model you

are using.

• Supported Web browsers are Internet Explorer 6/7/8.

• The menu displays only in English.

• If the browser of your computer is set to [Use a proxy server] when you access to the projector

from your computer, click the check mark to set accessing without using a proxy server.

1 Connect the LAN cable.

2 Set the network settings for the

projector using “LAN Settings” on the

Connection/Power menu (page 27).

3 Start a web browser on the computer,

enter the following in the address field,

then press the Enter key on your

computer.

http://xxx.xxx.xxx.xxx

(xxx.xxx.xxx.xxx: IP address for the

projector)

You can confirm the IP address of the

projector in the “LAN Settings” on the

Connection/Power menu (page 27).

The following window appears in the

Web browser:

Once you make the network settings,

you can open the Control window only

by performing step 3 of this procedure.

Notes

Displaying the Control Window of the Projector with a Web

Browser

LAN cable

(straight type)

(not supplied)

Hub, router, etc

LAN Connector