User's Manual

Projecting an Image

Projecting/Adjusting an Image

Correcting trapezoidal distortion of the projected image (Keystone feature)

Normally the Keystone feature automatically adjusts the projected image. The Keystone

feature may not work automatically if the screen is tilted. In this case, set Keystone manually.

1 Press the KEYSTONE key on the remote

commander or select V Keystone in the

Installation menu.

2 Use the V/v/B/b keys to set the value. The

higher the value, narrower the top of the

projected image. The lower the value, the

narrower the bottom.

Since the Keystone adjustment is an electronic

correction, the image may be deteriorated.

Automatically adjusts Phase, Pitch and Shift of projected image while a

signal is input from a computer (APA (Auto Pixel Alignment))

Press the APA key on the remote commander. Press again to cancel adjusting during the setting.

You can also set APA in the Screen Menu (page 22). If Smart APA in the Function menu is set

to “On”, executes APA automatically when a signal is input (page 25).

Note

Increase the number

towards plus

Increase the number

towards minus