User Guide
Table Of Contents
- Table of Contents
- Overview
- Operating the Camera
- Administrator and User
- Logging in to System
- Configuration of Main Viewer
- Main menu
- Control panel section
- Monitor image
- Plug-in free viewer
- Using Solid PTZ function
- Controlling via the control panel (Operation common to Area zoom mode and Vector dragging mode)
- Panning and tilting by clicking the monitor image (Area zoom mode only)
- Panning, tilting and zooming by specifying the area (Area zoom mode only)
- Panning and tilting by dragging the screen (Vector dragging mode only)
- Switching Transmission Mode
- Administrating the Camera
- Basic Operations of the Administrator Menu
- Configuring the System - System Menu
- Setting the Camera Image and Audio - Video / Audio Menu
- Configuring the Network - Network Menu
- Setting the Security - Security Menu
- Setting the PTZ control - PTZ control Menu
- Setting the Sensor input/Camera tampering detection/Motion detection - Action input Menu
- Event condition Tab
- Sensor input Tab - Set the sensor input 1/2
- Camera tampering detection Tab - Set the camera tampering detection
- Motion detection Tab - Set the motion/VMF detection
- What is VMF
- Setting items for motion detection
- VMF settings
- Network disconnection Tab - Monitoring the connection of a specified IP address
- Setting the Action output - Action output Menu
- Setting the Schedule - Schedule Menu
- Others
Administrating the Camera
Configuring the Network — Network Menu
24
The IP address, subnet mask, default gateway are
assigned automatically. To obtain DNS server
addresses automatically, select Obtain DNS server
address automatically. To set manually, deselect
Obtain DNS server address automatically, and
type the address in the Primary DNS server and
Secondary DNS server boxes.
Note
When you select Obtain an IP address
automatically (DHCP), make sure that a DHCP
server is operating on the network.
To specify the IP address manually
Deselect Obtain an IP address automatically
(DHCP). Type the address in the IP address,
Subnet mask, Default gateway, Primary DNS
server and Secondary DNS server boxes. Host
name and Domain suffix are not available.
MTU
Enter the MTU value for the Ethernet port. (1280 -
1500)
Common setting
Host name
Type the host name of the camera to be transmitted
to the DHCP server. This setting is valid only when
Obtain an IP address automatically (DHCP) is
selected.
Domain suffix
Type the domain suffix of the camera to be
transmitted to the DHCP server. This setting is valid
only when Obtain an IP address automatically
(DHCP) is selected.
Note
The domain suffix is sent to the DHCP server as
FQDN (Fully Qualified Domain Name)
information when Host name is set.
HTTP port number
Normally select 80. If you want to use a port
number other than 80, select the text box and type a
port number between 1024 and 65534.
Note
When you have set the HTTP port number to a
number other than 80 in the Network menu or in
SNC toolbox, access the camera again by typing the
IP address of the camera on your Web browser as
follows:
Example: Setting port number 8000 when IP
address is 192.168.0.100
OK/Cancel
See “Buttons common to every menu” on page 14.