Operation Manual

The Timer22

Waking up to music (continued)

Tips

• To exit the standby

mode, press STANDBY

to make the t

indication disappear

from the display.

• The preset settings

remain until you reset

them.

Note

When you press ( or

r button of the tape

player in the timer

mode:

If the tape length of one

side is longer than the

set time, the player will

be turned off at the end

of the tape, not at the

set time.

6 Press TUNING•TIME SET + or – to set the

volume, then DSPL ENT MEM.

7 Press STANDBY.

The t indication lights up and the power goes off.

At the preset time, the power will go on, and the

music will play. Then the power will go off at the

preset time, and the player will enter the standby

mode.

To check/change when the playback will start

Press TIMER, then DSPL ENT MEM. Each time you

press DSPL ENT MEM, a stored setting is displayed in

the set order. To change the setting, display the setting

you want to change and reenter it.

To use the player before a timer playback starts

Just turn on the player, and then you can use it.

If you turn off the player before the preset time, timer

playback will start at the preset time.

In case of the radio, however, if you listen to the

station which is different from the one you tuned in

step 1 on page 21, you will hear that station at the

preset time. Make sure to tune in the station you want

to listen to before you turn off the player.

To stop play

Press OPERATE to turn off the power.