Operation Manual

NAS-Z200DiR/Z200iR.GB.4-151-738-12(1)
63
GB
Precautions/Specifications
Precautions/Specifications
Precautions
On safety

Completely disconnect the power
cord (mains lead) from the wall
socket (mains) if it is not going to
be used for an extended period of
time. When unplugging the unit,
always grip the plug. Never pull
the cord itself.

Should any solid object or liquid
get into the unit, unplug the unit,
and have it checked by qualified
personnel before operating it
again.

The AC power cord can be
changed only by a qualified
service facility.
On placement

Do not place the unit in an
inclined position or in locations
that are extremely hot, cold,
dusty, dirty, or humid or lacking
adequate ventilation, or subject
to vibration, direct sunlight or a
bright light.

Be careful when placing the
unit or speakers on surfaces that
have been specially treated (for
example, with wax, oil, polish) as
staining or discoloration of the
surface may result.

If the unit is brought directly
from a cold to a warm location
or is placed in a very damp room,
moisture may condense on the
lens inside the CD player, and
cause the unit to malfunction. In
this situation, remove the disc,
and leave the unit turned on for
about an hour until the moisture
evaporates.
On heat buildup

Heat buildup on the unit during
operation is normal and is not
cause for alarm.

Do not touch the cabinet if it has
been used continuously at a high
volume because the cabinet may
have become hot.

Do not block the ventilation
holes on the rear of this unit.
Doing so will prevent the heat
produced by the unit’s amplifier
to build up, which may cause the
unit to malfunction. Make sure
these holes are free from any
obstruction.
When moving the unit
Do not move the unit while a CD
is inserted. Doing so may damage
the CD.
About AC power adaptor

Use the AC power adaptor
supplied with this unit. Do not
use any other AC power adaptor
since it may cause this unit to
malfunction.
Polarity of the plug

Connect the AC power adaptor
or the power cord to an easily
accessible AC outlet. Should you
notice an abnormality in the AC
power adaptor or the power cord,
disconnect it from the AC outlet
immediately.

The unit is not disconnected from
the AC power source (mains) as
long as it is connected to the wall
outlet, even if the unit itself has
been turned off.

If you are not going to use this
unit for a long time, be sure to
disconnect the power supply. To
remove the AC power cord from
the wall outlet, grasp the adaptor
plug itself; never pull the cord.
On disposing of the remote
control
Before disposing of the remote
control, the built-in battery should
be removed for environmental
protection.
Notes

Do not remove the screws at the
bottom of the remote control
except when disposing of the
remote control.

Before removing the built-
in battery, make sure it has
completely drained.
Do the following procedure to
remove the built-in battery.
1 Remove the two screws at
the bottom of the remote
control.