Basic Menu Operations tae 1 Be wet 1 Press the + or Burton repeatedly unl the function to be set appears. 2 Hold down the SET button until the item to be set flashes, 3 4 Precise SE tube to eaten the setting. Press the + or bunion to change the sating.
Grafter denier FS The while holding downtime SET button, turn the power on. Then change the setting after the signal transmission bas stopped. Be sure to select the grouchiness right after selecting the frequency band. To start signal cans mission with the selected frequency bandfgronp/channed, turn off the power and then furn it on again. . Selecting the group/channel (PINCH) See “Carder Frequencies and Channel Steps” on page 19 for factory settings. For details, see “Selecting the group/channel” on pug 6.
Setting the battery type (BATTERY TYPE) Set this item discerning fo the type of batteries you use to obtain accurate battery power stars ing ion. TYPE: The power status is indicated based on characteristics of new LR6 {size AA) Sony Alkaline batteries. Select this for LRG (size AA) alkaline batteries.
Tahighwindlenk rein Conical ic futon dia be controlled from the receiver and other devices. For details an wireless remote control function, see “Using the Cross Remote” on page 7. Locking the POWER switch (power SW LOCK) The POWER SITE EI be Rooked i prevents administrate Born blag accidentally dodo avail, Even when the POWER switch Toked, all pans of the transmitter other than the DOWER seismographic functional.
Attaching With the Soft Case “Phi transfinite cin Be hellcat 10:06 ser With Hire supplied soft aye, All generations are possible Bon the Sonsmitiorisittadhed with the soft case. The clip can be attached to the soft case at an angle of 0, 6, 180; or 270 degrees, allowing you t attach the transmitter in a variety of positions. Removing the clip Remove the transit fom he soft case before clinging or removing the supplied dip. 1 Remove the transmitter from the soft case.
Block Diagram 45 V {output Hat GND ROTARIAN |p mmm mm mmm : Digital signal prophetess | 1 Head amp.
Troubleshooting I you encounter a problem using this jasmine, use the following checklist finds solicitor: For any problems withe receiver ar adapter, refer to the operating instructions supplied with the respective device. If the problem persists, consult your Sony dealer.
important Notes on Operation Notes on using the transmitter + “the digital wireless microphone system product must be used within a temperature range (32°F 0 122 °F. Operating the transmitter near electrical equipment {miters, transformers, or dimmers) may cause ito be affected by electromagnetic induction. Keep the transfinite as far from such equipment as possible. The presence of the lighting equipment may produce electrical interference over the entire frequency range.
Specifications Transmitting section Oscillator type Crystal-controlled PLL synthesizer RF power output Tea WO WISH mW specifiable Antenna type 2/4 flexible wire Occupied RE bandwidth 192 kHz or less MODEL LS ms MODE: L Oms MODE: 2.8 ms Allowable deviation of transmission frequency +5.