User's Guide Part 1

PushTalk
81
Operations during PushTalk Communication
Operation Key operation
Speak When the floor is open, you can speak only while you press and
hold
.
While another member has the floor, you cannot get it even if you
press
.
Add a member Press
(Add). This operation is enabled only when you originate a
PushTalk call.
Switch ON/OFF of the
hands-free operation
Press
( ). Every time you press the key, the ON/OFF setting is
switched.
Adjust the volume of the
caller’s voice
Press
.
Terminate a PushTalk call Press
.
Receive a voice call Press
(P.65).
If you receive a voice call, the PushTalk communication is terminated.
The operation for an incoming voice call while using PushTalk can be
customized (P.90).
●
Each speech session granted by obtaining the floor is time limited. The obtained floor is
released after the time limit. The PushTalk communication is terminated if no member takes
over the floor within a certain interval.
●
When there is any change in PushTalk communication status or a member takes over the
floor, the signal tone sounds.
●
You cannot use i-mode during PushTalk communication.
●
When other functions are activated, you cannot obtain the floor. However, when you activate
a function while you have the floor, you can speak while you press and hold
.
●
When you receive a videophone call, data communication, or a PushTalk call during
PushTalk communication, a new call is saved in the Received record and the current
PushTalk call is continued.