Manual
Table Of Contents
- Analogue Redbox User Handbook rev 1.92
- Contents
- Figures
- Warranty, Safety & Installation Information
- RB-MA1 Single & RB-MA2 Dual Microphone Amplifiers
- RB-SM1 Single & RB-SM2 Dual Stereo To Mono Converter
- RB-UL1 Single, RB-UL2 Dual & RB-UL4 Quad Stereo Unbalanced
- RB-LU4 Quad Stereo Balanced To Unbalanced Converter
- RB-BL2 Single & RB-BL4 Dual Bi-Directional Matching Converte
- RB-SL2 Twin Mono, or Stereo, Limiter
- RB-DA6 6 Way Stereo Distribution Amplifier
- RB-HD1 Stereo Headphone Amplifier
- RB-HD6 6 Way Stereo Headphone Distribution Amplifier
- RB-SD1 Silence Detection Unit
- RB-PMX4 10 Input, 4 Output Analogue Preset Mixer
- RB-LI2 Stereo Line Isolation Unit
- RB-PLI6 6 Way Mono Passive Line Isolation Unit
- RB-SS10 10 Way Stereo Analogue Source Selector/Mixer
- RB-LC3 3 Way Light/Power Controller
- Glossary
- Connectors And Cabling
- Index
Chapter 13 - RB-PLI6 6 Way Mono Passive Line Isolation Unit
Redbox User Handbook 13-3
Ground
Link for
Output 1
Ground
Link for
Output 2
Ground
Link for
Output 3
Ground
Link for
Output 4
Ground
Link for
Output 5
Ground
Link for
Output 6
Ground
Link for
Input 1
Ground
Link for
Input 2
Ground
Link for
Input 3
Ground
Link for
Input 4
Ground
Link for
Input 5
Ground
Link for
Input 6
JI1 JI2 JI3 JI4 JI5 JI6JO1 JO2 JO3 JO4 JO5 JO6
Front of RB-PLI6
1
2
1
2
Off
13.3.3. Ground-link Internal Jumpers
The unit has jumpers that are used to balance either the input, or the output, about
ground. By default these are not fitted when the unit leaves the factory.
To get inside the RB-PLI6, observing anti-static precautions, undo the four crosshead
screws on the back panel at the far left and far right of the panel (2 at each end). Also
undo the small brass screws, which hold the top and bottom panels to the rear panel.
The rear panel should slide backwards out of the unit together with the main circuit
board.
Fig 13-4: RB-PLI6 Ground-link Jumper Settings