Manual
Table Of Contents
- Analogue Redbox User Handbook rev 1.92
- Contents
- Figures
- Warranty, Safety & Installation Information
- RB-MA1 Single & RB-MA2 Dual Microphone Amplifiers
- RB-SM1 Single & RB-SM2 Dual Stereo To Mono Converter
- RB-UL1 Single, RB-UL2 Dual & RB-UL4 Quad Stereo Unbalanced
- RB-LU4 Quad Stereo Balanced To Unbalanced Converter
- RB-BL2 Single & RB-BL4 Dual Bi-Directional Matching Converte
- RB-SL2 Twin Mono, or Stereo, Limiter
- RB-DA6 6 Way Stereo Distribution Amplifier
- RB-HD1 Stereo Headphone Amplifier
- RB-HD6 6 Way Stereo Headphone Distribution Amplifier
- RB-SD1 Silence Detection Unit
- RB-PMX4 10 Input, 4 Output Analogue Preset Mixer
- RB-LI2 Stereo Line Isolation Unit
- RB-PLI6 6 Way Mono Passive Line Isolation Unit
- RB-SS10 10 Way Stereo Analogue Source Selector/Mixer
- RB-LC3 3 Way Light/Power Controller
- Glossary
- Connectors And Cabling
- Index
Chapter 14 - RB-SS10 10 Way Stereo Analogue Source Selector/Mixer
14-8 Redbox User Handbook
14.4.7. Status Outputs
This 25 way D-type socket (female) connector contains the remote status tallies.
Pin No. Signal Name I/O Description
Pin 1 REMTALLY1 O Internal open collector to ground for output 1
Pin 2 REMTALLY2 O Internal open collector to ground for output 2
Pin 3 REMTALLY3 O Internal open collector to ground for output 3
Pin 4 REMTALLY4 O Internal open collector to ground for output 4
Pin 5 REMTALLY5 O Internal open collector to ground for output 5
Pin 6 REMTALLY6 O Internal open collector to ground for output 6
Pin 7 REMTALLY7 O Internal open collector to ground for output 7
Pin 8 REMTALLY8 O Internal open collector to ground for output 8
Pin 9 REMTALLY9 O Internal open collector to ground for output 9
Pin 10 REMTALLY10 O Internal open collector to ground for output 10
Pin 11 N/C - No internal connection
Pin 12 N/C - No internal connection
Pin 13 GND - Signal ground
Pins 14 to
23
+5V O To supply up to a maximum of 100mA
Pin 24 N/C - No internal connection
Pin 25 N/C - No internal connection
Fig 14-10: Status Output Pin Connections
Pins 1 to 10 are to replicate the front panel push button indicators. An example of
how to connect the signals is shown below.
Pins 11, 12, 24 and 25 have no connection inside the unit.
Fig 14-11: Connection Example
R
Remote Tally 1 to 10
(Pins 1 to 10)
+5V
(Pins 14 to 23)