Installation Guide

Opening Conduit Drill Guides
This section describes how to open the AC and DCdrill guides.
This step may be performed before or after mounting the inverter.
To open conduit drill guides:
1.
Ensure that the Connection Unit and inverter ON/OFF switch are set to OFF.
2.
Loosen the screws on the front cover of the Connection Unit.
Figure 15: Opening the Connection Unit cover
3. Remove the Connection Unit cover.
4.
Open the required AC and DCconduit openings according to the conduits used in
the installation.
The conduit entries (usually covered)and the drill guides are located at the bottom
of the enclosure.

Figure 16: Connection Unit drill guides
Chapter 3: Installing the Primary and Secondary Unit(s) 35
Three Phase Inverter with Synergy Technology Installation MAN-01-00401-1.5