Install Manual
Table Of Contents
- Disclaimers
- Support and Contact Information
- Revision History
- HANDLING AND SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Introducing the SolarEdge Power Harvesting System
- Chapter 2: Installing the Power Optimisers
- Chapter 3: Installing the Inverter
- Chapter 4: Connecting the AC and the Strings to the Safety Switch
- Chapter 5: Activating, Commissioning and Configuring the System Using the Inverter SetApp
- Chapter 6: Setting Up Communication
- Appendix A: Errors and Troubleshooting
- Appendix B: Mechanical Specifications
- Appendix C: External Fan Maintenance and Replacement
- Appendix D: Replacing and Adding System Components
- Technical Specifications - Three Phase Inverters (North America)
NOTE
When mounting an inverter on an uneven surface, you may use spacers/ washers behind the top
mounting hole of the bracket. Depending on the angle, use the appropriate size and number of spacers
so that the bracket is perpendicular to the ground. Recommended: a stainless steel 3/4" long screw,
with a 1/4" socket button head , two jam nuts and three washers.
5. Hangtheinverteronthebracket(seeFigure17):Lifttheinverterfromthesides,orholditatthetop
andbottomoftheinvertertolifttheunitintoplace.DonotliftholdingtheSafetySwitchDCSafety
Unitasitmaybedamaged.
6.
Alignthetwoindentationsintheinverterenclosurewiththetwotriangularmountingtabsofthe
bracket,andlowertheinverteruntilitrestsonthebracketevenly.
Figure 17: Hanging the inverter on the bracket
7. SecuretheSafetySwitchbrackettothewall:
8. ForinverterswithSafetySwitch-securetheSafetySwitchbrackettothewall:
l MarkthelocationofthebracketscrewfortheSafetySwitchanddrillthehole.
l Fastenthebracketusingastandardbolt.
Chapter 3: Installing the Inverter
-Three Phase System Installation Guide MAN-01-00527-1.1
31