Install Manual

Figure 14: Safety Switch drill guides
NOTE
Unused conduit openings and glands should be sealed with appropriate seals.
Mounting the Inverter
Theinverteristypicallymountedvertically,andtheinstructionsinthissectionare
applicableforverticalinstallation.Somethreephaseinvertermodelscanbeinstalled
horizontally(above10°tilt)aswellasvertically,andatanytiltover10°upto90°.For
informationandinstructionsforhorizontalmountingreferto
http://www.solaredge.com/sites/default/files/application_note_horizontal_mounting_
of_three_phase_inverters.pdf.
Theinverterissuppliedwithamountingbracket.
Figure 15: Mounting bracket
NOTE
Make sure the mounting surface or structure can support the weight of the inverter and bracket, and
make sure that it spans the width of the bracket.
CAUTION!
HEAVY OBJECT. To avoid muscle strain or back injury, use proper lifting techniques, and if required - a
lifting aid.
ATTENTION!
Objet lourd. Pour éviter la fatigue musculaire ou des blessures au dos, utilisez des techniques de levage
appropriées et, si nécessaire - un auxiliaire de levage lors du retrait.
CAUTION!
SolarEdge inverters and power optimizers can be installed at a minimum distance of 50 m/ 164 ft from
the shoreline of an ocean or other saline environment, as long as there are no direct salt water splashes
on the inverter or power optimizer.
ATTENTION!
Les onduleurs SolarEdge peuvent être installés à une distance minimum de 50m de la ligne d'eau de
l'océan ou autre environnement salin, tant qu'il n'y a pas d'éclaboussements d'eau salée directs sur
l'onduleur.
-Three Phase System Installation Guide MAN-01-00527-1.1
28
Mounting the Inverter