Use and Care Manual

ManualsBrandsSnapSafe ManualsHome Safes0.6807 cu. ft. 26 in. W x 5 in. H x 20 in. D Medium Under Bed Safe with Digital Lock

Owner’s Manual

Under Bed Safe

Item No. 75402

Customer Service: PO Box 1848, Grand Island, NE 68802-1848

1-877-214-4470 | Email: info@snapsafe.com

586006 / REV 1 19SNAP0036 | 09/2019

Ext. Dimensions: 26.0" x 5.0" x 20.0"

Int. Dimensions: 23.5" x 3.5" x 14.3"

LOW BATTERY WARNING

If the batteries become weak, the keypad will remain red during operation.

Replace batteries immediately to ensure proper operation of the safe.

SECURITY CABLE INSTALLATION

There are holes located on both

sides of the safe for installing the

security cable.

1. Loop the cable around a secure

object and then insert the

threaded end of the cable through

the loop of the cable.

2. Remove the plastic plug on the

side of the safe.

3. Open the drawer just far enough

that the hole in the side of the

drawer aligns with the hole in the

side of the housing.

4. Insert the threaded stud into the

side of the safe and install the

nut. NOTE: The nut only needs

to be tightened until the nylon

thread lock engages.

NOTE: The drawer can be removed

to make installing the security cable

easier or to permanently bolt down

the safe.

To remove the drawer, fully extend

the drawer and then locate the

small lever inside each drawer

slide. Press up on the right lever

and down on the left lever. With the

levers pressed, carefully pull out the

drawer for removal.

To reinstall the drawer, carefully

align the slides on each side and

then press the drawer in. The levers

should click into place.

Weight: 55 Lbs

Power: 4 AA batteries (not included)

Threaded

Stud

Drawer Lever

Threaded Stud

Inserted in Housing

Summary of content (2 pages)

PAGE 1
LOW BATTERY WARNING If the batteries become weak, the keypad will remain red during operation. Replace batteries immediately to ensure proper operation of the safe. SECURITY CABLE INSTALLATION There are holes located on both sides of the safe for installing the security cable. 1. Loop the cable around a secure object and then insert the threaded end of the cable through the loop of the cable. 2. Remove the plastic plug on the side of the safe. 3.
PAGE 2
POWER 1. Remove key override cover by pressing on either end of the cover. 2. Open the safe with the mechanical override key. 3. Remove the battery cover inside the door. 4. Insert 4 AA batteries and replace the battery cover. 5. Do not close the door before testing digital lock. Key Override Cover Press here or here to remove cover Note: Do not store keys in safe.