Titan Safe Owner’s Manual
Thank you for purchasing a SnapSafe® Titan. Now you have the peace-of-mind knowing your valuables are protected from loss due to fire or theft. Best of all, you can easily locate or relocate this protection anywhere piece-by-piece to any room in minutes. The SnapSafe® Modular Assembly System offers all the impregnability of a welded safe in an easy-to-assemble modular design. YOUR COMBINATION CODE • Your factory preset combination code is 1-2-3-4-5-6.
CHANGING YOUR COMBINATION CODE Write down and store a new 6-digit code. Do not store in safe. You cannot set the combination code to six (6) zeros (0). 1. Open safe door and lock it in open position. 2. Enter zero (0) six (6) times. One beep sounds indicating the entry is valid and the system is awaiting a code change. 3. Enter the existing 6-digit code. One beep sounds, indicating the entry is valid. 4. Enter a new 6-digit code. One beep sounds, indicating the entry is valid. 5.
BACKUP MECHANICAL KEY OVERRIDE WARNING: Store key in a secure location away from the safe. To access key override slot, gently slide digital keypad up and away from door to remove keypad. NOTE: When digital keypad is removed, handle keypad and cable carefully to prevent damage to cable. UNLOCK Place key into slot as shown and rotate clockwise. With key rotated, rotate door handle clockwise to retract locking lugs and open door. LOCK Fully close door.
ASSEMBLING YOUR TITAN SAFE 1. Unpack and lay out all parts. 2. Thread DOOR HANDLE SPOKES onto the hub on DOOR (Part 12). 3. Install a fresh, high-quality 9V battery in the Entry Keypad. 4. Important — Remove temporary door hinge screws from door hinges. 5. Enter the factory combination code of 1-2-3-4-5-6 and open the door. Then lift it off the DOOR FRAME (Part 6) and set aside. 6. Assemble Top, Bottom and Sides (Parts 1 through 4) first.
ORDER OF ASSEMBLY Loosely tighten bolts BATTERY AND SPOKE HANDLES LEFT SIDE TOP RIGHT SIDE BOTTOM NOTE: When inserting interior panels, tuck front edge in first, then slide back edge into place.
BOTTOM INTERIOR PANEL STAND SAFE UPRIGHT AND HANG DOOR DIVIDER GUN RACK DIVIDER TOP SHELVES
BOLTING DOWN YOUR SAFE We recommend bolting your safe to the floor using two ¼” wedge anchor concrete bolts through the predrilled holes in the BOTTOM of the safe. CARE AND MAINTENANCE With a little care and maintenance your SnapSafe® Titan Safe will last a lifetime. Keep the door hinge pins lightly greased so that the door opens smoothly. Vacuum the inside from time to time, and wipe down the outside with a soft cloth and mild detergent.
