User's Manual
Table Of Contents
- 17 MARS-3102 User Manual_0904
- 17 MARS-3102 User Manual_0731
- Safety Information
- Contents
- Using This Manual
- Introduction
- Getting Started
- Navigation
- Scanner Operations
- OBD Direct Operations
- Component Test Operations
- Scope Multimeter Operations
- Ask-a-Tech Operations
- Information Operations
- Vehicle History Operations
- Data Manager Operations
- Help Operations
- System Settings Operations
- Maintenance
- Software License Agreement, North America
- Index
- 文件2
- 17 MARS-3102 User Manual_0731
- RF Exposure Information (SAR) CCS
81
Scope Multimeter Operations Operations
• Low Amps (20)
• Low Amps (40)
• Low Amps (60)
• MC Dwell (60)
• MC Dwell (90)
• 100 psi Vacuum
• 100 psi Pressure
• 500 psi Pressure
• 5000 psi Pressure
• MT5030 Vacuum
• MT5030 Pressure
• EEDM506D Temperature
Digital Multimeter Options
The following options are available for testing:
• Volts DC
• Volts DC Average
• Volts AC RMS
• Ohms
• Diode/Continuity
• Low Amps (20)
• Low Amps (40)
• Low Amps (60)
8.4.2 Scope and Multimeter Setup
The following sections explain how to adjust the scope and multimeter for the specific type of
signal being sampled. Most of these setup operations are available from the toolbar.
Trace Controls
The Trace controls are used to adjust individual characteristics of how the signal is sampled and
displayed for each of the four traces.
z To adjust trace controls:
1. Select Setup from the Scope Multimeter toolbar.
The Scope Multimeter Preferences dialog box opens
2. Select Traces to open the submenu.
3. Select the trace to be configured from the submenu.
The traces dialog box displays (
Figure 8-17).