Installation Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
SRC Classic Sides (Part # 76636)
07-10 Jeep Unlimited (4-Door)
Parts Included Qty Parts Included Qty
Driver Side Bar 1 10 x 25mm Hex Bolt 4
Passenger Side Bar 1 10mm Flat Washer 4
Nut-Clip 4 8mm Flat Washer 2
6mm Flat Washer 12 8 x 25mm Hex Bolt 2
6mm Ny-lock Nut 12
Step 1: Remove oem or aftermarket side rails/steps if equipped. (Fig A)
Step 2: Identify the passenger and driver side. Place the passenger side guard onto the
vehicle by lining up the 6 tabs (2 front , 2 center and 2 back) on the guard with the
already existing holes on the pinch weld area of your vehicle. (On some models you
may need to drill 2 holes) Fig A
Step 3: Identify the two holes (one front and one in the center) on the bottom of the body that the
Nut-clips will be inserted into by where the top brackets of the guard align with. (You may
Need to remove some tape that is applied from the factory that is covering the holes)
Fig B,C,D
(Fig A) (Fig B)
NOTE: Carefully read entire instructions thoroughly before attempting to install this part.
Line up the 6 tabs (2 front, 2 center and 2
back) on the guard with the already
existing holes on the pinch weld area of
your vehicle.
You may need to remove some tape that is
applied from the factory that is covering the
holes. (Front passenger side pictured)