Installation Guide

ManualsBrandsSmeg ManualsMajor AppliancesRange

Table of Contents

1 Installation 9

1.1 Product dimensions 9

1.2 Unpacking, moving and positioning the range 12

1.3 Electrical connection 13

1.4 Wall and floor attachment 14

1.5 For the installer 18

Important Notes to the Installer

• Read all instructions contained in these installation instructions before

installing the range.

• Remove all packing material from the oven and the drawer compartments

before connecting the electrical supply to the range.

• Observe all governing codes and ordinances. Be sure to leave these

instructions with the consumer.

Important Note to the Customer

• Keep these instructions with your owner's guide for future reference.

Definitions

• This manual contains important safety symbols and instructions.

• Please pay attention to these symbols and follow all instructions given.

IMPORTANT SAFETY INSTRUCTIONS

WARNING

If the instructions contained in this manual are not followed

precisely, a fire or explosion may result causing property

damage, personal injury or loss of life.

INSTALLATION AND SERVICE MUST BE PERFORMED BY A

QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR THE LOCAL INSPECTOR’S USE.

Summary of content (16 pages)

PAGE 1
Table of Contents 1.1 1.2 1.3 1.4 1.5 Product dimensions Unpacking, moving and positioning the range Electrical connection Wall and floor attachment For the installer 9 EN 1 Installation 9 12 13 14 18 IMPORTANT SAFETY INSTRUCTIONS WARNING If the instructions contained in this manual are not followed precisely, a fire or explosion may result causing property damage, personal injury or loss of life. INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
PAGE 2
Important Safety Instructions WARNING This symbol will help alert you to situations that may cause serious bodily harm, death or property damage. CAUTION This symbol will help alert you to situations that may cause injury or property damage. TIP OVER HAZARD WARNING: Tip Over Hazard • A child or adult could tip the range over and be killed. • Install the anti-tip device on the floor or wall as per the installation instructions.
PAGE 3
Safety Codes and Standards This appliance complies with one or more of the following Standards: UL 858 - The Standard for the safety of Household Electric Ranges CAN/CSA-C22.2 No. 61 Household Cooking Ranges • It is the responsibility of the owner and the installer to determine whether additional requirements and/or standards apply to specific installations.
PAGE 4
Important Safety Instructions • THIS COOKTOP IS NOT REMOVABLE. Do not attempt to remove the cooktop. WARNING Do not repair, replace or remove any part of the appliance unless specifically recommended in the manuals. Improper installation, service or maintenance can cause injury or property damage. Refer to this manual for guidance. All other servicing should be done by an authorized service provider.
PAGE 5
Related Equipment Safety • The appliance should only be used if installed by a qualified technician in accordance with these installation instructions and all applicable regulations and codes. The manufacturer is not responsible for damages resulting from incorrect installation. • Remove all tape and packaging before using the appliance. Dispose of the packaging after unpacking the appliance. Never allow children to play with packaging material. • Never modify or alter the construction of the appliance.
PAGE 6
Important Safety Instructions High altitude installation • This appliance can operate up to an altitude of 10,000 ft. (3048 m.) elevation above sea level. If desired, for altitudes above 2,000 ft (610 m) elevation above sea level, adjustments may be made. • It is required that a Certified Professional make the high altitude adjustments during installation.
PAGE 7
Important Safety Instructions EN 1 Installation 1.1 Product dimensions Overall dimensions: Location of electrical connection point. L A 5 1/8" 130 mm B 1 1/8" min. 3 1/4" Max. 4 7/16" 31 7/8" 35 15/16" 29 mm F H L E = Electrical connection min. 83 mm Max. 113 mm 809 mm 912.4 mm M1 N2 O 35 15/16" 912.4 mm min. 24 5/8" Max. 25” 42 13/16" min. 626 mm Max. 630 mm min. 35 1/8" Max. 36 5/16" min. 892 mm Max.
PAGE 8
Installation Cabinet clearances 1 min. clearance from the sides of range to side wall or other combustible material; 2 min. cabinet opening width; 3 upper cabinet to countertop; 4 max. upper cabinet depth. The side cabinet depth (clearance B) must match the front edge of the range side panel. A B C1 G2 I3 L 36" 914 mm 25” 630 mm 20" 508 mm min. 36" min. 914 mm 18" 457 mm see notes below 13" 330 mm 13" 330 mm M4 P4 Clearance L can have the following values: • L = 30” (762 mm) min.
PAGE 9
Location of the electric outlet D M min. 11 7/8” min. 2” Min. 300 mm Max. 9 7/8” Max. 250 mm 7 L Keep a minimum clearance of 5 7/8" (150 mm) between the appliance and the other furnishings or decorative elements according to the diagram below. min. 51 mm min. 11 /8” min. 300 mm Max. 24 2/8” Max. 614 mm Island installation If the appliance is installed as an island: 1. Unscrew the screws shown. 2. Remove the spacers (A). 3. Replace the screws that were previously removed.
PAGE 10
Installation 1.2 Unpacking, moving and positioning the range CAUTION This unit is designed as a cooking appliance. For safety reasons, never use it for warming the room or as a space heater. • When positioning the appliance during installation, do not use the door handle to lift or move this appliance. • Remove the outer carton and packing material from the shipping base. • Remove angle-mounting brackets from the range.
PAGE 11
The appliance must sit level on the floor to ensure stability: • Screw or unscrew the bottom part of the foot until the appliance is stable and level on the floor. The adjustment range of the screw is 1.18“(30 mm). 3. Once you have fixed the backguard to the appliance, you must insert the screws and spacers provided that are necessary for the slot-in installation. 1.3 Electrical connection NOTE: this appliance must only use the specific leveling legs provided by the manufacturer.
PAGE 12
Installation WARNING The rating plate is visibly located on the right side of the oven door frame. This ID plate must never be removed. Electrical shock hazard • Disconnect the electrical supply before servicing the appliance • It is the personal responsibility of the consumer to have the appropriate outlet or junction box with the correct, properly grounded wall receptacle installed by a qualified electrician.
PAGE 13
CAUTION • Contact a qualified installer or contractor to determine the proper method for drilling holes through the wall or floor material (such as ceramic tile, hardwood, etc.) • Failure to follow these instructions may result in damage to wall or floor coverings. WARNING Visually check from the inside of the drawer that the wall/floor-mounted bracket is inserted into the appropriate lateral hook (left side). WARNING: Tip Over Hazard • A child or adult could tip the range over and be killed.
PAGE 14
Installation Installing the anti-tip bracket 1. Ensure that the electrical connection is in the correct position. 2. Assemble the bracket. NOTE: The wall attachment is recommended if the appliance is placed against a wall. Floor attachment is recommended in case of island installation. 5. Use the specified distance from the side of the appliance to the bracket holes. 3. Align the base of the hook of the bracket with the base on the slot of the rear wall fastening bracket.
PAGE 15
7. Use the following distances for the distance from the side of the appliance to the bracket holes. EN Installation WARNING The rear vent trim has 3/16” (5 mm) standoffs to keep the appliance slightly away from the back wall. Do not remove or tamper with standoffs due to potential temperature issues. 9. Push the cooker towards the wall, and at the same time, insert the bracket in the plate that is fastened to the rear of the appliance. 8.
PAGE 16
Installation Door removal It is not necessary to remove the door in order to install the range, but is an added convenience. Refer to the Use and Care Guide for the oven door removal instructions. 1.5 For the installer • The plug must remain accessible after the installation is complete. Do not kink or trap the mains connection cable. • The appliance must be fitted according to the installation diagrams. • When satisfied with the appliance, please instruct the user on the correct method of operation.