FAQ 1 - Change the cartridge/knob MI3 MI4 MI1 MID5 MIDR55 1 2 5 6 4 3 MID2 MID1
MIR6 MICOR9 4 5 6 MIR8 1 2 3 4 5 6 3 2 1
2 - Cleaning products that can be used without damaging the mixer's finishing NEUTRAL SOAP SOFT • only use products with a neutral pH value specifically supplied for this type of use; • never use cleaning materials containing hydrochloric acid, formic acid, chlorine bleach or acetic acid, as they cause considerable damage; • acid phosphorus detergents can be applied only under certain conditions; • mixing of different detergents is generally not permitted; • never use cleaning materials or equipment with
3 - Is there a leak in the mixer? SOLUTION: Check whether the leak is at the base of the part (SOLUTION A) or under the lever (SOLUTION B) SOLUTION A: Replacement of hoses: SOLUTION B: Replacing the cartridge (SEE POINT 1)
4 - Change the aerator or pull-out spray Our mixers do not require any particular maintenance, except for periodic cleaning of the aerator, which collects debris and scale on the internal screen, causing a gradual loss of flow over time. To clean the aerator screen, proceed as follows: unscrew the aerator by turning it counter-clockwise. Remove impurities from the filter screen by using running water and/or soaking it in vinegar to dissolve scale (do not immerse chrome-plated or finished parts).
REPLACEMENT OF PULL-OUT SPRAY HEAD: MID5 MIDR55 MIDR7 MID2 MID1SS MID1 MID1SS 1 5 - Water flow is reduced even when the lever is fully open Check that there is no dirt inside the aerator filter. Remove the aerator and proceed with cleaning (SEE POINT 4) 6 - Lever is hard during opening/closing A possible build-up of scale blocks the movement.