Refrigerator Instructions for Installation and Use

Instructions for the user
14
9. MAINTENANCE AND CLEANING
9.1 Defrosting the refrigerator compartment
The refrigerator compartment has automatic defrosting. During normal operation of the refrigerator, frost
forms on its back wall when the compressor is working and dissolves when it is not in operation. When
the compressor is not working, the frost which has built up on the back wall melts and the water flows
into the opening provided in the bottom of the body of the refrigerator. From here, it flows into the tray on
the compressor, where it evaporates.
Warning
the amount of ice which forms on the back wall may vary with changes in weather conditions
(temperature and humidity), the frequency with which the door is opened, the appliance's operating
temperatures and the amount of fresh foods stored inside (especially fruit and vegetables).
9.2 Defrosting the freezer
The freezer compartment has to be defrosted manually. When the thickness of frost or ice on the shelves
exceeds 2 cm, the freezer should be defrosted. A few hours before defrosting, use the knob provided to
set the thermostat on 7 in order to further lower the temperature of the frozen foods. Then turn the knob
to the 0 (stop) setting and disconnect the plug from the electrical mains. Remove the frozen foods from
the freezer compartment and protect them from thawing while cleaning. For the FAB32 model, fit the
pipe provided into the groove in the bottom of the appliance. Place a container underneath the pipe to
collect the defrosted water.
9.3 Cleaning the refrigerator
Before cleaning, disconnect the plug from the electrical mains. Clean the outside using only water and a
gentle liquid detergent or an ordinary detergent for washable surfaces (such as a window-cleaning
product). Never use products containing abrasives or substances which may attack the lacquered or
painted parts, acids or chemical solvents. Use a sponge or a soft cloth.
Do not use steam cleaners to clean the inside; we recommend the use of specific disinfectants. Specific
SMEG-brand products for cleaning steel are available from our Service Centres.
Remove the shelves and accessories, taking care not to apply excessive force when removing. Follow
the instructions provided in the "Door Shelves and Containers" section carefully. Never wash removable
plastic parts in the dishwasher; use only warm water and washing-up liquid or water and vinegar. Take
care not to wet the electrical lighting components with water or detergents.
Clean the gaskets with warm water and then dry.
To allow the refrigerator to operate at full efficiency, periodically also clean the
condenser on the rear with a brush or a vacuum cleaner.
Also make a periodic check on the tray above the compressor, and clean it if
necessary.
9.4 Switching off the refrigerator
If the refrigerator is to be out of use for some time, turn the thermostat knob to 0 (stop). For model
FAB32, proceed as explained above to switch off the refrigerator section, and press the switch provided
on the controls display to switch off the freezer. Then empty the compartments, disconnect the appliance
from the electrical mains, and once it has defrosted dry any residual moisture which has collected. Leave
the door ajar to prevent the humidity and trapped air from creating unpleasant smells.