Datasheet

ManualsBrandsSMC ManualsAutomationModular Filter Controller, G1/4, 800 L/min

Selection

Maintenance

Mounting/Adjustment

Port size M5 x 0.8

Pressure gauge port size

Note)

1/16

Fluid Air

Ambient and fluid temperature –5 to 60°C (with no freezing)

Proof pressure 1.5 MPa

Maximum operating pressure 1.0 MPa

Set pressure range 0.05 to 0.7 MPa

Construction Relieving type

Weight [kg] 0.06

Standard Speciﬁ cations

Bracket assembly

Note 1)

AR12P-270AS

Set nut AR12P-260S

Round type pressure gauge

Note 2)

G27-10-R1

Options/Part No.

Note 1) Assembly of a bracket and set nuts

Note 2) 1.0 MPa pressure gauge

Speciﬁ c Product Precautions

1. Although exhaust of the residual pressure to the inlet side is

possible when eliminating the inlet pressure, exhaust is not

possible when the set pressure is 0.15 MPa or less.

Warning

1. When using the regulator between a solenoid valve and an ac-

tuator, check the pressure gauge periodically. Sudden pres-

sure ﬂ uctuations may shorten the durability of the pressure

gauge. A digital pressure gauge is recommended for such

situation or as deemed necessary.

Warning

1. Set the regulator while verifying the displayed values of the in-

let and outlet pressure gauges. Turning the regulator knob ex-

cessively can cause damage to the internal parts.

2. Do not use tools on the pressure regulator knob as this may

cause damage. It must be operated manually.

Warning

1. Be sure to unlock the knob before adjusting the pressure and lock

it after setting the pressure. Failure to follow this procedure can

cause damage to the knob and the outlet pressure may ﬂ uctuate.

• Pull the pressure regulator knob to unlock. (You can visually

verify this with the “orange mark” that appears in the gap.)

• Push the pressure regulator knob to lock. When the knob is not

easily locked, turn it left and right a little and then push it (when

the knob is locked, the “orange mark”, i.e., the gap will disap-

pear).

2. Pulsation will be generated when the difference between the

inlet and the outlet pressure is large. In this case, reduce the

pressure difference between the inlet and the outlet. Please

consult with SMC if the pulsation problem is not resolved.

Caution

Be sure to read this before handling. Refer to the back cover for Safety Instructions, “Handling Precautions for

SMC Products” and the Operation Manual for F.R.L. Precautions, http://www.smc.eu

Note) Use a bushing (part no.: 131368) when connecting the R1/8 pressure gauge to the Rc1/16.

Regulator Series AR10-A



ALAW



ALAF



ARAF



AFM



ARAW



AFM

AF Attachment

AFM / AFD

ARALAW