User's Manual

Page 13 of 32 2474DWH- Rev: 3/6/2012 10:13 AM
Figure 4: Installed correctly
Figure 5: Installed incorrectly
9) Gently place the paddle assembly back onto front of SwitchLinc. A little force may be necessary
to snap the assembly over the Set button. Reinstall four screws that you removed in step 2.
Specifications
General
Product name
SwitchLinc 2-Wire Dimmer - INSTEON Remote Control
Dimmer
Brand / manufacturer INSTEON
Manufacturer product number 2474DWH
UPC 813922010817
Warranty 2 years, limited
INSTEON
INSTEON powerline mesh No
INSTEON RF mesh Yes
INSTEON controller Yes
INSTEON responder Yes
Maximum links / scenes 400
Load brightness levels 32 locally (256 with software)
LED Behavior
White when load is on, bottom white LED is on when load is off
Blinks red when responder does not acknowledge (can be
disabled via software).
Blinks red or green during setup.
LED brightness Adjustable, from off to bright
Local on-level Adjustable, 32 fixed brightness levels or resume dim
Local ramp-rate
Adjustable from 0.1 seconds to 9 seconds locally (0.1 seconds
to 8 minutes via software)
Local control Yes
On Off
Fast-on Fast-off
Begin bright Begin dim
Commands supported as controller
End bright End dim