Installation Guide

Check the water valve in the bathroom. You may need to consider purchasing additional components.
For the following below case, the T-valve and conversion nut included alone should be
Minus home Handle
Inner bolt for water valve
■ Water supply valve ■ Inner bolt water valve
ᆞ Please consult with a qualified specialist.
ᆞ Please put the unused water hose in a secure area.
■ Professional engineering is needed for plumbing
work on specialized water pipes and flush valve pipes.
ᆞ This product requires 120V usage.
ᆞ Please do not plug in the electrical cord prior to installation.
ᆞ Please consult with a licensed electrician if electrical work is needed, and in case a grounded outlet
is not available, grounding should be done in order to prevent short circuits or electric shock.
ᆞ Please contact our service center(1-800-515-3430) when you want to reinstall the bidet product(move or replacement).
Caution
Shut water supply by turning it to the
right and detach the water hose.
Water supply hose
Water valve
Remove existing seat and lid.
ᆞ unscrew the bolts the bolts
on both sides of the
existing toilet seat to
remove the seat
and lid.
ᆞ Store the removed seat,
nut and water hose in a
safe area in case you
move or it needs to be
reinstalled.




Connect the water supply hose to the
T-valve. Insert the packing in the T-valve.
Connect the water supply hose to the
assembled T-valve.
Conversion Nut
(with packing)
T-valve
(with packing)
If the water supply hose is old or
damaged please replace it with
the water supply hose included
with the unit.
※ If the water supply valve opening is 1/2 inch please use
a conversion nut to connect it with the T-valve.
※ Included 1/2" conversion nut is OD Compression, not FIP.
※ T-valve packing must be used to prevent water from leaking.
Nut
Toilet
body
Exisiting toilet seat
Once the base plate is attached to the
unit, align the unit and toilet fixture facing
front, and then insert the mounting bolts
to the toilet mounting holes.
Put the bolt into the bolt case and align
it with the top of the base plate. Insert
bolt with bolt case onto the base plate.
After this is done hold the bolts, slide it
into the bottom of the unit until it snaps
in place.
Install the main unit and insert the
mounting bolts to the toilet mounting
holes.
Connect the flexible tube from side of
T-valve to the unit. Turn the water valve
to the left to allow water to flow.
Installed bolt case
Bolt
Bolt
Back
Base plate
Cone Packing
Nut
Water supply valve
Water supply hose for
electronic toilet seat
1110
5
Installation
Check the water valve
Installation steps




Cone Packing
Nut
E
N
G
L
I
S
H
※ Customers should use the new hose set provided with the product.
Do not use used set again.