User's Manual

11
DISASSEMBLY
DISASSEMBLY CONTINUED
06 07
08
10
05
09
04
15
800.922.2147 www.smartparts.com
Unscrew the body breech from the fi re
chamber, and remove the bolt from in-
side. If the bolt stop does not come out
with the bolt, pull it out with a fi nger.
Remove the Vision circuit board from the body breech
and set aside carefully. This circuit board is shaped
like the letter C, and should come easily out of place.
Take care to make sure that the infra-red emitter and
detector (these look like clear LEDs) are not set on
anything that can scratch them.
Keeping the upper receiver upside down,
slide out the inner receiver components.
Unscrew the remaining two banjo fi t-
tings with a 1/8-inch allen wrench.
Locate the Vision wiring harness. This
group of four black wires runs from
the lower circuit board to the Vision
circuit board in the body breech.
Unplug the Vision wiring harness from
the body end, being careful not to
strain the wires by tugging on them.
As much as possible, pull on the
connector directly.
The clear plastic power button will be
free to fall out of the grip frame - make
sure it does not get lost.
Set the grip frame aside, and hold the
upper receiver upside down (with the
sight rail facing down.)
Remove the front banjo fi tting from the grip frame
with a 1/8-inch allen wrench. The center of the
banjo fi tting will turn with the wrench, pivoting
inside the rest of the fi tting. Gently complete the
process of separating the upper receiver from
the grip frame. Take care to make sure that the
circuit board slides out of the grip frame without
being strained, and that the battery wires and
battery clip follow without snagging.
Grasp the upper receiver with one hand and
the grip frame with the other. Slowly pull
the body away from the grip frame, rolling it
slightly to the side, exposing the top of the
grip frame and banjo fi tting. Gently pushing
upward on the bottom of the circuit board
with a thumb can help it to slide upward.