User's Manual

01 02 03 04
0605
Using the 5/32” Allen wrench, unscrew and remove the two grip
frame screws.
CAREFULLY separate the grip frame from the body, paying careful
attention to the wiring harness attached to the circuit board at the
midway point of the grip frame. Pull wiring through grip frame gently
and set aside grip frame assembly.
The wiring harness carries
electrical signals between the
Shocker NXT’s lower (grip frame)
circuit board and the Vision
circuit board which is mounted
on the solenoid valve. Remove
the wiring harness by getting as
close to the lower circuit board
as possible and gently removing
the wiring harness plug in a
careful side to side motion until
the harness plug comes free.
It is not necessary to remove
the 9-volt battery from the
grip frame, but you may nd
it easier to complete the next
step if you rst remove the 9-
volt battery and unplug it from
the battery clip.
Remove the four screws that hold
the rubber grip on the grip frame,
and remove the rubber grip.
Degas the Shocker NXT. Discon-
nect the macroline running from
the ASA or compressed air
regulator to the Shocker NXT’s
vertical regulator.
Use caution while handling the Shocker NXT Body. Excess strain on
the solenoid valve can damage the ne threads of its mount screws.
The Solenoid valve should not be removed during normal mainte-
nance.
FIG. 23
WIRING HARNESS
FIG. 25
PORT INSERTS
Due to the internal gas ltering built into the Shocker
NXT, removal and or disassembly of the solenoid
valve is not required during regular maintenance and
may actually shorten its service life. Leave it where it
is and lead a happy life.
FIG. 24
REMOVING GRIP FRAME
Located below the Bolt Guide on the rear of the Shocker NXT are the threaded ends of two port inserts.
The Port Inserts are slender rods equipped with very ne o-rings. They serve to divide gas passages
inside the Shocker NXT. Correct installation of the Port Inserts requires the use of specialized pneumatic
alignment equipment at the Smart Parts factory. Improper installation can damage the Port Insert seals
and misalignment will prevent the Shocker NXT from functioning. The Port Inserts and their o-rings are
non-wear items and do not ever need to be removed for the Shocker NXT for anything short of body mill-
ing or anodizing. Even if someone offers you free beer and pizza, do not remove the Port Inserts.
INSTALLATION OF PORT INSERTS
WIRING HARNESS
INSERT
INSERT
G R I P F R A M E R E M O VA L
18
800.922.2147 www.smartparts.com