User's Manual

Q U I C K S TA R T
01 02
03
Using a 5/64-inch Allen wrench,
remove the two screws from
the left side of the rubber grip,
and lift the panel open. Attach
a fresh 9-volt alkaline battery
to the battery clip. Position the
battery in the grip frame, tucking
the battery wires into the space
above the battery. Close the grip
and reinstall the screws.
Screw the included barrel
into the Shocker NXT. Put
the supplied barrel blocker
over the end of the barrel,
securing its cord as far
back on the Shocker NXT
body as possible, and
cinching it tight.
Fill the loader with paint and turn it on. While wearing ASTM compliant paintball goggles in an area where all bystanders are protected, remove the barrel blocker and re over a
chronograph to measure the velocity. Using a 3/32-inch Allen wrench, loosen the velocity lock screw near the bottom of the vertical regulator and adjust it with a 5/8-inch open-end
wrench or adjustable wrench. Turn clockwise to increase velocity/pressure, and counter-clockwise to decrease. Take three or four shots after every adjustment to allow the gas
pressure inside the Shocker NXT to stabilize. Adjust until the Shocker NXT is ring consistently within the limits for the eld where you are playing (for safety reasons, never adjust
the Shocker NXT to re at greater than 300 feet per second.) As you adjust, check the Shocker NXT’s pressure gauge to be certain you stay within the Shocker NXT’s operating
limits of 180 to 220 psi. Lock the velocity setting by tightening the velocity lock screw. Depending on what modes of re are allowed at the eld where you are playing (semi-auto-
matic, rebound, etc.) you may need to adjust the Shocker NXT’s Rebound setting. See the Rebound Adjustment section for more information. Shoot out the competition, hang the
Insert your loader into the feed-
neck and make sure it is secure.
Due to the high rates of re that
Shocker NXT can achieve, we
recommend the use of a modern
high-performance loader.
Gently gas up the Shocker NXT
by slowly turning on the air
system or ASA’s on/off valve,
or slowly screwing the CO2 or
compressed air system into
the ASA.
A gentle rise in pressure is
important, as a sudden blast
may reduce the service life of
the Shocker NXT’s internals.
Turn on the Shocker NXT by
holding the power button down
for approximately 1 second. The
Shocker NXT will chirp and the
power button will glow continu-
ously to show that it is on and
in Vision mode. If you need to
disable Vision mode to re gas
without paint, push the button
once again, and the power
button will blink in a double-tap
sequence. Press and hold the
power button for approximately
2 seconds to turn the Shocker
NXT off, this acts as an elec-
tronic safety.
04 05 06
BATTERY BARREL BLOCKER FILL TANK
LOADER TURN ON AIR TURN ON SHOCKER
ADJUST VELOCITY
The SHOCKER NXT can be damaged by liquid CO2. Thoroughly
read and understand the Gasses Section of the manual before
using CO2 to avoid damage.
Have your compressed air
(HPA) or CO2 tank lled by
a person who is properly
trained to do so. If using an
HPA system with an on/off
valve, such as the Max-Flo
or Max-Flo Micro, make sure
it is in the OFF position. If
using a screw-in style preset
HPA tank, or CO2 tank, an
ASA with a built in on/off
valve is recommended.
07
00
800.922.2147 www.smartparts.com