Operation Manual

Connection:

1. AC CORD

Used this cable to connect the AC mains power to the unit

2. POWER BUTTON

Press the power switch to turn the unit on. To switch the POWER off press the POWER switch

again.

3. GND

Grounding lug for turntable connection. Always use this connection when using turntables.(your

turntable cable should have a grounding wire)

4. LINE/PHONO INPUT SWITCH

Use this to allow either line level or phono level equipment to be plugged into your channel inputs.

when phono input is selected, your signal is fed directly to the high-quality RIAA phono pre-

amplifiers. Line level sources will overload the sensitive phono pre-amps and will sound very bad,

so always be sure to toggle the line/phono switch over to line before connection of line sources.

5. INPUT

Plug in the line level device such as tape deck or additional CD player here.

6. DJ MIC

Plug XLR type microphone plug in here.

7. MIC INPUT

Plug 1/4” microphone plug in here.

8. STEREO MAIN OUTPUT

Unbalanced RCA connectors controlled by the master fader.