help@lifereiver.
.. Balancing Kit ....................................................... 13 Please use carefully when working around or cleaning the fan to avoid injury or damage of fan.
14.3 16.2 9 10 S13 Hardware Package S1. Blade Screw S2. Machine Screw S3. Machine Screw S4. Wood Screw S5. Wire Nut S6. J-hook S7. Lock Washer S8. Star Washer S9. Washer S10.Paper Washer S11.Lock Washer S12.Washer S13.
Yoke Screws Paper Washers Lampshade
Step1 MOUNTING Take out To ensure wobble - free operation and to avoid damage to the fan, the downrod and the set screws must be completely tightened .
Step2 MOUNTING BLADES TO MOTOR Motor Screws Paper Washers
Step3 LIGHT KIT . (connect WHITE light kit unit wire to WHITE fan wire, connect BLUE light kit unit wire to BLUE fan wire) - Place disfuser onto the fan and turn to secure.
Step4 MOUNTING BRACKET TO MOTOR WARNING: To reduce the risk of fire, electric shock, or personal injury, mount to UL/CSA listed outlet box marked acceptable for fan support and use mounting screws provided with the outlet box. Fig. 4a Fig. 4b Step5 ELECTRICAL HOOK-UP A.Make the following wire connections using the wire nuts supplied. a To the household supply wires -Connect the following 4 GREEN wires to the GREEN supply wire. 1. GREEN wire from the downrod 2. GREEN wire from the receiver 3.
AC SUPPLY CIRCUIT 120V/60Hz GROUND WHITE BLACK RECEIVER BLACK(AC-L) WHITE(AC-N) GREEN OUTLET BOX BLUE (FOR LIGHT L) GREEN FROM MOUNTING BRACKET WHITE (FOR LIGHT N) GREEN FROM DOWNROD GREEN FROM MOTOR PINK RED ORANGE WHITE (FOR LIGHT N) BLUE (FOR LIGHT L) ORANGE(TO MOTOR) PINK(TO MOTOR) RED(TO MOTOR) 6 MOTOR NOTE: Once ground wires are connected, carefully tuck all wires and wire nuts into the metal box making sure that the wires are clear of the hemisphere and downrod when positioned in hem
C.FUNCTION INSTRUCTION OF EMITTER Learning code and matching mode is used between emitter and receiver. - Open battery cover on the hand-held remote and install battery, pair of AAA of emitter (1.5V) that are not included. - If the emitter can not control the fan, learning code matching mode is used between emitter and receiver.
- Place two screws and washers on mounting bracket which correspond with slots in canopy. Screw in two turns. - Carefully rotate fan assembly until groove in hemisphere locks over tab of canopy assembly. - Loosen (do not remove) the two screws on mounting bracket. Slide the canopy up to mounting bracket and place the key hole on the canopy over the screw on the mounting bracket, turn canopy until it locks in place at the narrow section of the key holes.
work Check the main and branch circuit fuses or breakers. Check the line wire connections to the fan and switch wire connections in the switch housing. Check the battery in the remote control. Ensure you are in the normal range of 10-20 feet. Ensure all motor housing screws are snug. Ensure the screws that attach the fan blade bracket to the motor hub are tight. Ensure the wire nut connections are not rattling against each other or the interior wall of the switch housing.
If the fan wobble problem has not been corrected you can try to improve the balancing further by using the balancing clip and additional weights.