Installation Guide

ManualsBrandsSirius ManualsCooking Accessories125-150mm Under Eave Ducting Kit

SIRIUS “EASYEAVE 150/200” installation guide.

Sirius ducting kits are a high quality and simple, complete solution in a box. They provide an

ideal ventilation path to efficiently exhaust your kitchen fumes, steam, heat and odours –

filtered through your rangehood to the outside atmosphere.

Please check that there is a clear path for your ducting to run prior to installation, making sure

to look out for TV, computer, telephone and electrical cables, water and gas pipes, insulation

mater

ials and air conditioning pipes and duct, before cutting holes.

For new homes, ideally fit the basic ducting (pipe) components at the frame up stage.

Additional lengths of ducting, joins, galvanised steel angled elbows and all other ducting

accessories are available from your local retailer where you purchased your SIRIUS EasyKIT.

For further advice please call our ducting consultation service on Ph: 1300 762 219 (A

ustralia

only) or visit www.siriusbrand.com

and fill in the fields and one of our trained consultants will

assist you in the best manner possible.

Fig.1.

Installation Guide

(Disclaimer) The following instructions are provided as a guide only and in no way constitute or replace your local council requirements or Australian and New Zealand Standards and Building Codes.

Please Note: As shown in Fig.1. – the ducting used is 150mm Ø and dimensions to the point of convergence are based on a 45⁰ roof pitch…

• Semi-Rigid duct can bend reasonably sharply without impeding air-flow and as shown in Fig.1. and from the centre of the vent, to the point of

convergence is 250mm.

Professional Ducting Range

Eave Vent

Rangehood

Ducting

Summary of content (2 pages)

PAGE 1
SIRIUS “EASYEAVE 150/200” installation . guide Professional Ducting Range Ducting Eave Vent Sirius ducting kits are a high quality and simple, complete solution in a box. They provide an ideal ventilation path to efficiently exhaust your kitchen fumes, steam, heat and odours – filtered through your rangehood to the outside atmosphere.
PAGE 2
Obviously if there is an increase or decrease in the pitch (angle) of the roof, these measurements will vary slightly… • After checking that there is a clear path to run the ducting, check measure the distance from the Vent position in the eaves, back to where the ducting will connect to the rangehood collar. N.