Installation Guide

Bath Sinks: Drop-In

Drop-In sinks are designed to be easy to install in a wide range of

countertop materials. Sinkology copper sinks make updating your

bathroom design effortless.

1. Flip sink upside down and trace outside edge onto craft paper

orcardboard.Addasecondline1/2”inchinsidetherstline.

Cut out the center of the template using the second line.

2. Place the template on the countertop and trace the template.

Cut the installation hole in the countertop.

3. Position the sink in the hole and check for gaps around the rim.

Eliminate gaps by gently tapping the rim with a rubber mallet.

4. Weighthesinkdownandapplypolyurethaneexpandingfoam

underneath the sink to seal the gap between the sink and the

countertop to secure the sink

in place.

5. Use plumbers putty on the

underside of the drain lip to

seal the drain to the sink. See

diagram.

6. Apply Sinkology antique

brown or clear neutral cure 100% silicone around the rim of

the sink to form a water tight seal. See our Complete Silicone

InstallationKit(#SINSTALL-101) for Copper Sinks.

7. For regular maintenance simply wash with gentle soap

and water. For extra protection against water spotting, use

Sinkology Copper Armor care kit (#SARMOR-101) or high quality

carnauba wax.

8. Register your new sink at sinkology.com/registration.

Important

Sinkology bathroom drop-in sinks do not use mounting hardware. Our

preferred mounting method requires expanding foam and 100% silicone

to secure your copper sink into place.

PRO

DIY